ASTM B0019-20 - Standard Specification for Cartridge Brass Sheet, Strip, Plate, Bar, and Disks
Standard Specification for Cartridge Brass Sheet, Strip, Plate, Bar, and Disks
| Standard number: | ASTM B0019-20 |
| Released: | 01.04.2020 |
| Status: | Active |
| Pages: | 7 |
| Section: | 02.01 |
| Keywords: | bar; brass bar; brass disks (blanks); brass plate; brass sheet; brass strip; cartridge brass bar; cartridge brass disks (blanks); cartridge brass plate; cartridge brass sheet; cartridge brass strip; disks (blanks); plate; strip; UNS No. C26000; |
1.1 This specification establishes the requirements for sheet, strip, plate, bar, and disks for the manufacture of ammunition component parts thereof from alloy UNS C26000.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units, which are provided for information only and are not considered standard.
1.2.1 Exception—Values given in inch-pound units are the standard except for grain size, which is stated in SI units.
1.3 The following safety caveat pertains only to the test method described in Section 10 of this specification.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.