ASTM C0301-18R22 - Standard Test Methods for Vitrified Clay Pipe
Standard Test Methods for Vitrified Clay Pipe
| Standard number: | ASTM C0301-18R22 |
| Released: | 01.09.2022 |
| Status: | Active |
| Pages: | 4 |
| Section: | 04.05 |
| Keywords: | absorption; acid resistance; bearing strength; clay pipe; corrosion; corrosion resistance; hydrostatic; inspection; loading; pipe; segmented bearing; testing procedure; tests; three-edge bearing; vitrified clay pipe; |
1.1 These test methods cover the equipment for, and the techniques of, testing vitrified clay pipe prior to installation. Tests using whole pipe determines the resistance to crushing and hydrostatic forces. Tests using pipe fragments measure the amount of water absorption of the pipe body and the quantity of acid-soluble material that may be extracted from it.
Note 1: The following standards also apply to clay pipe and can be referenced for further information: Practice C12 and Test Method C828; Specifications C425 and C700.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.