ASTM C1701_C1701M-17AR23 - Standard Test Method for Infiltration Rate of In Place Pervious Concrete
Standard Test Method for Infiltration Rate of In Place Pervious Concrete
| Standard number: | ASTM C1701_C1701M-17AR23 |
| Released: | 01.10.2023 |
| Status: | Active |
| Pages: | 3 |
| Section: | 04.02 |
| Keywords: | concrete; infiltration; pervious; water; |
1.1 This test method covers the determination of the field water infiltration rate of in place pervious concrete.
Note 1: For permeable unit pavement systems, Test Method C1781/C1781M should be used. Test Method C1781/C1781M is functionally identical to this test method but includes added provisions for positioning and securing the test ring to a discontinuous surface. Both tests methods give comparable results
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 The text of this standard references notes that provide explanatory material. These notes shall not be considered as requirements of the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.