ASTM D0095-23E01 - Standard Test Method for Water in Petroleum Products and Bituminous Materials by Distillation
Standard Test Method for Water in Petroleum Products and Bituminous Materials by Distillation
| Standard number: | ASTM D0095-23E01 |
| Released: | 01.10.2023 |
| Status: | Active |
| Pages: | 6 |
| Section: | 05.01 |
| Keywords: | bituminous materials; distillation; petroleum products; solvent carrier liquid; water by distillation; water content; |
1.1 This test method covers the determination of water in the range from 0 % to 25 % by volume in petroleum products, tars, and other bituminous materials by the distillation method.
Note 1: Volatile water-soluble material, if present, may be measured as water.
1.2 The specific products considered during the development of this test method are listed in Table 1. For bituminous emulsions refer to Test Method D244. For crude oils, refer to Test Method D4006 (API MPMS Chapter 10.2).
Note 2: With some types of oil, satisfactory results may be obtained from Test Method D1796 (API MPMS Chapter 10.6).
1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 6.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.