ASTM D0283-13R19 - Standard Test Methods for Chemical Analysis of Cuprous Oxide and Copper Pigments
Standard Test Methods for Chemical Analysis of Cuprous Oxide and Copper Pigments
| Standard number: | ASTM D0283-13R19 |
| Released: | 01.06.2019 |
| Status: | Active |
| Pages: | 5 |
| Section: | 06.03 |
| Keywords: | chemical analysis; copper pigments; cuprous oxide pigments; |
1.1 These test methods cover procedures for the chemical analysis of cuprous oxide and copper pigments.
1.2 The analytical procedures appear in the following order:
|
| Sections |
| Total Copper | 7 |
| Total Reducing Power as Cuprous Oxide | 8 and 9 |
| Metallic Copper | 10 and 11 |
| Cuprous Oxide | 12 |
| Cupric Oxide | 13 |
| Metals Other than Copper | 14 – 16 |
| Chlorides and Sulfates | 17 and 18 |
| Acetone-Soluble Matter | 19 |
| Water | 20 |
| Stability | 21 |
| Coarse Particles | 22 |
| Coarse Particles Insoluble in Nitric Acid | 23 |
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.