ASTM D0346_D0346M-11R19E01 - Standard Practice for Collection and Preparation of Coke Samples for Laboratory Analysis
Standard Practice for Collection and Preparation of Coke Samples for Laboratory Analysis
| Standard number: | ASTM D0346_D0346M-11R19E01 |
| Released: | 01.08.2019 |
| Status: | Active |
| Pages: | 5 |
| Section: | 05.06 |
| Keywords: | alternate shovel method; coke; division; reduction; sampling; |
1.1 This practice covers procedures for the collection and reduction of samples of coke to be used for physical tests, chemical analyses, and the determination of total moisture.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.2.1 Values in SI units [or inch-pound units] shall be obtained by measurement in SI units [or inch-pound units] or by appropriate conversion, using the Rules for Conversion and Rounding given in IEEE/ASTM SI 10, of measurements made in SI units [or other units]. Values are stated in SI units when inch-pound units are not used in practice.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.