ASTM D1415-18 - Standard Test Method for Rubber Property—International Hardness
Standard Test Method for Rubber Property—International Hardness
Standard number: | ASTM D1415-18 |
Released: | 01.06.2018 |
Status: | Active |
Pages: | 7 |
Section: | 09.01 |
1.1 This test method covers a procedure for measuring the hardness of vulcanized or thermoplastic rubber. The hardness is obtained by the difference in penetration depth of a specified dimension ball under two conditions of contact with the rubber: (1) with a small initial force and (2) with a much larger final force. The differential penetration is taken at a specified time and converted to a hardness scale value.
1.2 This test method is technically similar to ISO 48.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Plastics - Standard atmospheres for conditioning and testing (ISO 291:2008)
ISO 6502-1:2018-Rubber — Measurement of vulcanization characteristics using curemeters-Part 1: Introduction
ISO 23529:2016-Rubber — General procedures for preparing and conditioning test pieces for physical test methods