ASTM D2126-20 - Standard Test Method for Response of Rigid Cellular Plastics to Thermal and Humid Aging
Standard Test Method for Response of Rigid Cellular Plastics to Thermal and Humid Aging
| Standard number: | ASTM D2126-20 |
| Released: | 01.12.2020 |
| Status: | Active |
| Pages: | 3 |
| Section: | 08.01 |
| Keywords: | dimensional change; dimensional stability; humid aging; rigid cellular plastics; thermal aging; |
1.1 This test method covers procedures for the thermal and humid exposure of rigid cellular plastics. Conditions used shall be agreed upon between the purchaser and the supplier.
Note 1: A list of commonly used exposure conditions is found in Table 1.
1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
Note 2: This test method is equivalent to ISO 2796 in the sampling and calculation sections. It is not equivalent to ISO 2796 in the procedure section.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.