ASTM D2513-24 - Standard Specification for Polyethylene (PE) Gas Pressure Pipe, Tubing, and Fittings
Standard Specification for Polyethylene (PE) Gas Pressure Pipe, Tubing, and Fittings
| Standard number: | ASTM D2513-24 |
| Released: | 01.07.2024 |
| Status: | Active |
| Pages: | 17 |
| Section: | 08.04 |
1.1 This specification covers requirements and test methods for material dimensions and tolerances, hydrostatic burst strength, chemical resistance, and rapid crack resistance of polyethylene pipe, tubing, and fittings for use in fuel gas pipelines for direct burial and reliner applications. The pipe and fittings covered by this specification are intended for use in the transmission and distribution of natural gas. Requirements for the qualifying of polyethylene systems for use with liquefied petroleum gas are also covered.
1.1.1 This specification does not cover threaded pipe. Design considerations are discussed in Appendix X1. In-plant quality control is specified in Section 9 for pipe and Section 10 for fittings.
1.1.2 Requirements for polyethylene piping for pressure or non-pressure oil and gas producing applications to convey fluids such as oil, dry or wet gas, multiphase fluids, and non-potable oilfield water are addressed in Specification F2619/F2619M.
1.2 The text of this specification references notes, footnotes, and appendixes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the specification.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 The following is an index of the annexes and appendix in this specification:
| Appendixes | Subject |
| Appendix X1 | Design Consideration |
| Appendix X2 | Quality Program |
1.5 The following precautionary caveat pertains only to the test method portion of this specification. This standard does not purport to address all safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.