ASTM D3308-12R22 - Standard Specification for PTFE Resin Skived Tape
Standard Specification for PTFE Resin Skived Tape
| Standard number: | ASTM D3308-12R22 |
| Released: | 01.05.2022 |
| Status: | Active |
| Pages: | 3 |
| Section: | 08.02 |
| Keywords: | fluorocarbon polymer; fluoropolymers; granular PTFE; polytetrafluoroethylene; PTFE; PTFE basic shapes; PTFE film; PTFE skived tape; |
1.1 This specification covers skived tape in thicknesses from 0.013 to 6.35 mm (0.0005 to 0.250 in.) manufactured by skiving (Note 1) from PTFE resin molding and extrusion materials.
Note 1: Skiving is the process of continuously shaving a film on a lathe from the outer surface to the core of a molded cylindrical tube of material.
Note 2: Abbreviations have been approved from Terminology D1600.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are for information only.
1.3 The following hazard caveat pertains only to the test method portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
Note 3: This specification and ISO 13000-1 and ISO 13000-2 differ in approach or detail, and data obtained using either may not be technically equivalent.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.