ASTM D3551-17 - Standard Practice for Laboratory Preparation of Soil-Lime Mixtures Using Mechanical Mixer
Standard Practice for Laboratory Preparation of Soil-Lime Mixtures Using Mechanical Mixer
| Standard number: | ASTM D3551-17 |
| Released: | 01.11.2017 |
| Status: | Active |
| Pages: | 3 |
| Section: | 04.08 |
| Keywords: | lime; Mechanical mixing; soil-lime; soil stabilization; |
1.1 This practice covers the laboratory preparation of soil-lime mixtures for use in determining the effects of lime on soil properties (plasticity, strength, moisture-density relations, etc.) and the design of mixtures for construction.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026.
1.3.1 The procedures used to specify how data are collected/recorded or calculated in this standard are regarded as the industry standard. In addition, they are representative of the significant digits that generally should be retained. The procedures used do not consider material variation, purpose for obtaining the data, special purpose studies, or any considerations for the user’s objectives; and it is common practice to increase or reduce significant digits of reported data to be commensurate with these considerations. It is beyond the scope of this standard to consider significant digits used in analysis methods for engineering design.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This practice offers a set of instructions for performing one or more specific operations. This document cannot replace education or experience and should be used in conjunction with professional judgement. Not all aspects of this practice may be applicable in all circumstances. This ASTM standard is not intended to represent or replace the standard of care by which the adequacy of a given professional service must be judged, nor should this document be applied without consideration of a project's many unique aspects. The word “Standard” in the title of this document means only that the document has been approved the ASTM consensus process.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.