ASTM D3794-22 - Standard Guide for Testing Coil Coatings
Standard Guide for Testing Coil Coatings
| Standard number: | ASTM D3794-22 |
| Released: | 15.06.2022 |
| Status: | Active |
| Pages: | 11 |
| Section: | 06.02 |
| Keywords: | absorbance; accelerated; acetic acid; adhesion; chip resistance; chromate; coil coatings; color; cone and plate; cyclic; density; dew cycle; film thickness; fame spread; fluorescent-UV condensation; Fresnel; glass transition; hardness; humidity; impact; irradiance; Kesternich; metamerism; methods; pH; phosphate; reflectance; salt spray; solar reflectance; solids; solvent resistance; standards; Taber; T bends; transmittance; viscosity; VOC; weathering; xenon; Zahn; |
1.1 This guide covers procedures for testing coil coatings. The test methods included are listed in Table 1. Where more than one test method is listed for the same characteristic, no attempt is made to indicate superiority of one method over another. Selection of test methods to be followed must be governed by the requirements in each individual case, together with agreement between the producer and user.
1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.