ASTM D3910-24 - Standard Practices for Design, Testing, and Construction of Slurry Seal
Standard Practices for Design, Testing, and Construction of Slurry Seal
| Standard number: | D3910-24 |
| Released: | 01.10.2024 |
| Status: | Active |
| Pages: | 8 |
| Section: | 04.03 |
| Keywords: | abrasion resistance; appropriate ratio-mix formula; emulsified asphalt cold mixture; fine-graded aggregate; mineral filler; mixing water; set and cure time; slurry seal; slurry seal consistency; specialized mixing and application equipment; |
1.1 These practices cover the design, testing, and construction of mixtures for surface treatment of pavements. It is written as a guide and should be used as such. End-use specifications should be adapted to conform to job and user requirements.
1.2 The values stated in SI units are to be regarded as the standard. The non-SI units used in this standard are allowed by the subcommittee for clarification in the use of the standard.
1.3 The text of this standard references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.