ASTM D4552_D4552M-20 - Standard Classification for Hot-Mix Recycling Agents
Standard Classification for Hot-Mix Recycling Agents
| Standard number: | ASTM D4552_D4552M-20 |
| Released: | 01.07.2020 |
| Status: | Active |
| Pages: | 4 |
| Section: | 04.03 |
| Keywords: | asphalt; hot-mix asphalt; recycling agents; |
1.1 This standard covers a standardized method whereby recycling agents to be used in hot recycling of asphalt concrete can be classified. The recycling agents are classified by viscosity in mm2/s measured at 60 °C [140 °F]. This classification does not apply to emulsified recycling agents.
1.2 This standard does not address the performance of asphalt binder blends with recycling agents, or that of hot-mix asphalt mixture containing recycling agents. Adherence of a recycling agent to this specification does not necessarily relate to the performance of asphalt binders and mixtures containing the recycling agents.
Note 1: The impact of recycling agents has been evaluated by extracting the asphalt binder from the pavement to be recycled, and combining with the recycling agent to meet the appropriate grade within Specification D946/D946M or Table 1, 2, or 3 of Specification D3381/D3381M. More recently, some specifications have referred to performance grading as described in Specification D6373 or D8239.
Note 2: Efforts are underway to utilize performance-based testing of the asphalt mixture containing recycling agents as a measure of compliance.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.