ASTM D4740-20 - Standard Test Method for Cleanliness and Compatibility of Residual Fuels by Spot Test
Standard Test Method for Cleanliness and Compatibility of Residual Fuels by Spot Test
| Standard number: | ASTM D4740-20 |
| Released: | 01.09.2020 |
| Status: | Active |
| Pages: | 7 |
| Section: | 05.02 |
| Keywords: | cleanliness; compatibility; residual fuel; spot test; |
1.1 This test method covers separate procedures for determining the cleanliness of residual fuel oil and the compatibility of a residual fuel oil with a blend stock. It is applicable to residual fuel oils with viscosities up to 50 cSt (1 cSt = 1 mm2s) at 100 °C. This test method describes two protocols: one manual and one automated.
Note 1: This test method has not been evaluated for heavy distillate having the propensity to leave a wax sediment on the filter paper and contain no residual asphaltene.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.