ASTM D4932_D4932M-89R19
Standard Test Method for Fastener Rupture and Tear Resistance of Roofing and Waterproofing Sheets, Roll Roofing, and Shingles
| Language: | English |
| Released: | 2019-05-30 |
| Pages: | 4 |
| Standards number: | ASTM D4932_D4932M-89R19 |
| Standard number: | D4932_D4932M-89R19 |
| Released: | 01.05.2019 |
| Status: | Active |
| Pages: | 4 |
| Section: | 04.04 |
| Keywords: | fastener rupture; roll roofing; roofing membranes; shingles; tear resistance ; |
1.1 This test method covers the determination of the force needed to pull a fastener through any type of roofing or waterproofing ply sheet, roll roofing, or shingle, or to cause fastener failure under specified laboratory conditions.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.