ASTM D5289-19A - Standard Test Method for Rubber Property—Vulcanization Using Rotorless Cure Meters
Standard Test Method for Rubber Property—Vulcanization Using Rotorless Cure Meters
| Standard number: | ASTM D5289-19A |
| Released: | 01.11.2019 |
| Status: | Active |
| Pages: | 9 |
| Section: | 09.01 |
| Keywords: | compounds; rheometer; rotorless cure meter; vulcanization characteristics; |
1.1 This test method covers a method for the measurement of selected vulcanization characteristics of rubber compounds using unsealed and sealed torsion shear cure meters. The two types of instruments may not give the same results.
Note 1: An alternative method for the measurement of vulcanization characteristics is given in Test Method D2084.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.