ASTM D5930-17 - Standard Test Method for Thermal Conductivity of Plastics by Means of a Transient Line-Source Technique
Standard Test Method for Thermal Conductivity of Plastics by Means of a Transient Line-Source Technique
| Standard number: | ASTM D5930-17 |
| Released: | 01.08.2017 |
| Status: | Active |
| Pages: | 5 |
| Section: | 08.03 |
| Keywords: | line-source probe; line-source technique; plastics; rubber; thermal conductivity; thermoplastics; thermosets; |
1.1 This test method covers the determination of the thermal conductivity of plastics over a temperature range from –40 to 400°C. It is possible to measure the thermal conductivity of filled and unfilled thermoplastics, thermosets, and rubbers in the range from 0.08 to 2.0 W/m.K.
1.2 The values stated in SI units shall be regarded as standard.
1.3 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish proper safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1: There is no known ISO equivalent to this test method.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.