ASTM D6210-17 - Standard Specification for Fully-Formulated Glycol Base Engine Coolant for Heavy-Duty Engines<rangeref></rangeref >
Standard Specification for Fully-Formulated Glycol Base Engine Coolant for Heavy-Duty Engines<rangeref></rangeref >
| Standard number: | ASTM D6210-17 |
| Released: | 01.11.2017 |
| Status: | Active |
| Pages: | 4 |
| Section: | 15.05 |
| Keywords: | cavitation; fully-formulated heavy-duty engine coolant; supplemental coolant additive maintenance dose; |
1.1 This specification covers the requirements for fully-formulated glycol base coolants for cooling systems of heavy-duty engines. When concentrates are used at 40 to 60 % glycol concentration by volume in water of suitable quality, (see Appendix X1), or when prediluted glycol base engine coolants (50 volume % minimum) are used without further dilution, they will function effectively during both winter and summer to provide protection against corrosion, cavitation, freezing, and boiling.
1.2 This specification is intended to cover the requirements for engine coolants prepared from virgin or recycled ethylene or propylene glycol.
Note 1: Committee D15 has not substantially studied the impact of using recycled glycols from sources such as: • glycol bottoms • polyester manufacturing waste • aircraft and runway deicers • medical waste
1.3 The coolants governed by this specification are categorized as follows:
| Coolant Type | Description |
|
|
|
| I-FF | Ethylene glycol base concentrate |
| II-FF | Propylene glycol base concentrate |
| III-FF | Ethylene glycol predilute (50 vol %) |
| IV-FF | Propylene glycol predilute (50 vol %) |
1.4 Coolant concentrates meeting this specification do not require any addition of Supplemental Coolant Additive (SCA) until the first maintenance interval when a maintenance dose of SCA is required to continue protection in certain heavy duty engine cooling systems, particularly those of the wet cylinder liner-in-block design. The SCA additions are defined by and are the primary responsibility of the engine manufacturer or vehicle manufacturer. If they provide no instructions, follow the SCA supplier's instructions.
1.5 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.