ASTM D6254_D6254M-20 - Standard Specification for Wirebound Pallet-Type Wood Boxes
Standard Specification for Wirebound Pallet-Type Wood Boxes
Standard number: | ASTM D6254_D6254M-20 |
Released: | 01.10.2020 |
Status: | Active |
Pages: | 14 |
Section: | 15.10 |
Keywords: | blank; box; fasteners; ISPM 15; nails; packaging; pallet; panelboard; shipping container; skid; staples; wire; wirebound; wood; |
1.1 This specification covers the fabrication of new fully enclosed wirebound pallet-type wood boxes intended for use as containers for domestic and overseas shipment of general materials and supplies, not exceeding 2500 lb [1134 kg] (see 4.1 and 10.1).
1.2 Wirebound pallet-type wood box performance is dependent on its fabricated components; therefore, a variety of types, classes, and treatments reflecting varied performance are specified (see 4). This specification, however, does not cover wirebound pallet-type wood box performance under all atmosphere, handling, shipping, and storage conditions.
1.3 The use of other construction methods or techniques is acceptable and permitted (see 5.1.11), provided the resulting packaging systems shall be of equal or better performance than would result from the use of these specified materials and procedures. The appropriate distribution cycle provided in Practice D4169 can be used to develop comparative procedures and criteria.
1.4 Units—The values stated in either inch-pound or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. See for conversion of units.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.