ASTM D7038-24 - Standard Test Method for Evaluation of Moisture Corrosion Resistance of Automotive Gear Lubricants
Standard Test Method for Evaluation of Moisture Corrosion Resistance of Automotive Gear Lubricants
| Standard number: | ASTM D7038-24 |
| Released: | 01.05.2024 |
| Status: | Active |
| Pages: | 26 |
| Section: | 05.03 |
| Keywords: | corrosion; final drive axle; gear failure; gears; lubricants; L-33-1; moisture; rust; |
1.1 This test method covers a test procedure for evaluating the rust and corrosion inhibiting properties of a gear lubricant while subjected to water contamination and elevated temperature in a bench-mounted hypoid differential housing assembly.2 This test method is commonly referred to as the L-33-1 test.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.2.1 Exceptions—(1) where there is no direct SI equivalent such as screw threads and national pipe threads/diameters, and (2) the values stated in SI units are to be regarded as standard for the definitions in 12.2, and for SI units where there are no direct inch-pounds equivalent units.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.