ASTM D7047-23E01 - Standard Test Method for Swell Volume of Plantago Insularis (Ovata, Psyllium)
Standard Test Method for Swell Volume of Plantago Insularis (Ovata, Psyllium)
| Standard number: | ASTM D7047-23E01 |
| Released: | 01.11.2023 |
| Status: | Active |
| Pages: | 4 |
| Section: | 04.09 |
| Keywords: | erosion control; insularis; mucilloid; ovata; plantago; psyllium; swell; |
1.1 The purpose of this quantitative test method is to provide a means of determining the swell volume plantago insularis (Ovata, Psyllium).
1.2 The volume of swell reflects the amount of hydrophilic mucilloid present in psyllium. The higher the grade of psyllium the higher the swell volume, thus a greater percent of mucilloid present. For the erosion control industry, the higher the swell volume of the psyllium the greater it’s bonding strength and relative performance.
1.3 Units—The values stated in SI units are to be regarded as the standard. No other units of measurement are included in this standard.
1.4 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026.
1.4.1 For purposes of comparing, a measured or calculated value(s) with specified limits, the measured or calculated value(s) shall be rounded to the nearest decimal or significant digits in the specified limits.
1.4.2 The procedures used to specify how data are collected/recorded or calculated, in this standard are regarded as the industry standard. In addition, they are representative of the significant digits that generally should be retained. The procedures used do not consider material variation, purpose for obtaining the data, special purpose studies, or any considerations for the user's objectives; and it is common practice to increase or reduce significant digits of reported data to be commensurate with these considerations. It is beyond the scope of this standard to consider significant digits used in analysis methods for engineering design.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.