ASTM E0238-17A - Standard Test Method for Pin-Type Bearing Test of Metallic Materials
Standard Test Method for Pin-Type Bearing Test of Metallic Materials
| Standard number: | ASTM E0238-17A |
| Released: | 01.04.2017 |
| Status: | Active |
| Pages: | 7 |
| Section: | 03.01 |
| Keywords: | bearing strength; bearing test; bearing yield strength; metallic materials; pin-type; |
1.1 This test method covers a pin-type bearing test of metallic materials to determine bearing yield strength and bearing strength.
Note 1: The presence of incidental lubricants on the bearing surfaces may significantly lower the value of bearing yield strength obtained by this method.
1.2 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.