ASTM E2681-21 - Standard Guide for Environmental Management of Underground Storage Tank Systems Storing Regulated Substances
Standard Guide for Environmental Management of Underground Storage Tank Systems Storing Regulated Substances
| Standard number: | ASTM E2681-21 |
| Released: | 01.09.2021 |
| Status: | Active |
| Pages: | 19 |
| Section: | 11.05 |
| Keywords: | compliance; Energy Policy Act of 2005; operator training; petroleum UST; tank system; underground storage tank; |
1.1 The framework discussed in this guide is limited to facilities with underground storage tanks (USTs) storing regulated substances at ambient temperature and atmospheric pressure. This guide is not intended to provide detailed technical specifications for implementation of the approaches described in this document, nor to be used as an enforcement tool, but rather to identify the important information used for environmental management of underground tank systems. The term “must” is used where United States federal requirements apply. References to ASTM standards and other industry guidelines have been provided to address implementation of the approaches discussed in this guide. Many states and some local agencies have adopted rules that place additional responsibilities on the owners/operators of UST systems. Refer to state and local regulations that may contain additional requirements. It is not possible to identify all considerations or combinations of conditions pertinent to a unique underground storage tank system.
1.2 This guide addresses principal considerations related to the prevention of, and response to environmental releases from tank systems and is organized in the sections listed below:
|
|
|
| Section 1: | Scope |
| Section 2: | Lists relevant ASTM Standards and other industry or regulatory guidance documents |
| Section 3: | Defines the key terminology used in this guide |
| Section 4: | Describes the significance and use of this guide |
| Section 5: | Tank System Design and Installation |
| Section 6: | Preventive Maintenance and Inspection Plan |
| Section 7: | Fueling Procedure |
| Section 8: | Dispensing Activities |
| Section 9: | Release Response Plan |
| Section 10: | Corrective Action for Affected Environmental Media |
| Section 11: | Tank System Closure |
| Section 12: | UST Management Practice and Operator Training |
| Appendix X1: | Recurring Release Detection and Cathodic Protection Requirements (Quick Glance) is intended to be a quick reference guide for monitoring information |
| Related Material: | Documents related to environmental management of underground storage tanks |
1.3 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Some specific hazards statements are given in Section 7 on Hazards.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.