ASTM F0793_F0793M-20 - Standard Classification of Wall Coverings by Use Characteristics
Standard Classification of Wall Coverings by Use Characteristics
| Standard number: | ASTM F0793_F0793M-20 |
| Released: | 01.10.2020 |
| Status: | Active |
| Pages: | 7 |
| Section: | 15.11 |
| Keywords: | abrasion resistance; blocking resistance; breaking strength; coating adhesion; cold cracking resistance; colorfastness; crocking resistance; flame spread index; flammability characteristics; heat aging resistance; shrinkage; scrubbability; smoke developed index; stain resistance; tear resistance; washability; wall covering; |
1.1 This classification covers the classification of wall coverings by use characteristics, that is, according to their serviceability in use, recognizing that certain wall coverings are designed primarily for decorative effect, while other wall coverings are also designed to achieve a high degree of serviceability.
1.1.1 This classification applies to any wall covering but some sections apply specifically to vinyl-coated wall covering materials.
1.1.2 Whenever this classification refers to wall coverings, it is intended also to refer to ceiling coverings of the same type.
1.1.3 This classification does not apply to wall coverings intended to be applied to exterior walls.
1.1.4 This classification does not apply to rigid panel products, irrespective of whether or not they include a flexible lining or veneer.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems has the potential to result in non-conformance with the standard.
1.3 This standard is used to measure and describe the properties of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.