ASTM F1058-25
Standard Specification for Wrought 40Cobalt-20Chromium-16Iron-15Nickel-7Molybdenum Alloy Wire, Strip, and Bar for Surgical Implant Applications (UNS R30003 and UNS R30008)
| Standard number: | ASTM F1058-25 |
| Released: | 15.01.2025 |
| Status: | Active |
| Pages: | 6 |
| Section: | 13.01 |
| Keywords: | cobalt alloys (for surgical implants); metals for surgical implants; wrought cobalt-chromium-nickel-molybdenum-iron alloy; |
1.1 This specification covers the chemical, mechanical, and metallurgical requirements for two grades of wrought 40cobalt-20chromium-16iron-15nickel-7molybdenum alloy in the form of wire, strip, and bar used for the manufacture of surgical implants.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.3 Any agreement between purchaser and supplier must meet the minimum requirements of this specification.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.