PRICES include / exclude VAT
Homepage>ASTM Standards>75>75.180>75.180.30>ASTM F2059-21 - Standard Test Method for Laboratory Oil Spill Dispersant Effectiveness Using the Swirling Flask
Sponsored link
Released: 01.09.2021

ASTM F2059-21 - Standard Test Method for Laboratory Oil Spill Dispersant Effectiveness Using the Swirling Flask

Standard Test Method for Laboratory Oil Spill Dispersant Effectiveness Using the Swirling Flask

Format
Availability
Price and currency
English PDF Redline
Immediate download
72.23 EUR
English PDF
Immediate download
60.67 EUR
English Hardcopy
In stock
60.67 EUR
Standard number:ASTM F2059-21
Released:01.09.2021
Status:Active
Pages:5
Section:11.08
Keywords:dispersant; dispersant testing; effectiveness testing; oil spill; swirling flask;
DESCRIPTION

1.1 This test method covers the procedure to determine the effectiveness of oil spill dispersants on various oils in the laboratory. This test method is not applicable to other chemical agents nor to the use of such products or dispersants in open waters.

1.2 This test method covers the use of the swirling flask test apparatus and does not cover other apparatuses nor are the analytical procedures described in this report directly applicable to such procedures.

1.3 The test results obtained using this test method are intended to provide baseline effectiveness values used to compare dispersants and oil types under conditions analogous to those used in the test.

1.4 The test results obtained using this test method are effectiveness values that should be cited as test values derived from this standard test. Dispersant effectiveness values do not directly relate to effectiveness at sea or in other apparatuses. Actual effectiveness at sea is dependent on sea energy, oil state, temperature, salinity, actual dispersant dosage, and amount of dispersant that interacts with the oil.

1.5 The decision to use or not use a dispersant on an oil should not be based solely on this or any other laboratory test method.

1.6 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.