ASTM F2163-01R25 - Standard Specification for Ring, Bearing, Inner: for Needle Roller Bearing With Drawn Outer Ring
Standard Specification for Ring, Bearing, Inner: for Needle Roller Bearing With Drawn Outer Ring
| Standard number: | ASTM F2163-01R25 |
| Released: | 01.01.2025 |
| Status: | Active |
| Pages: | 3 |
| Section: | 01.09 |
| Keywords: | drawn outer ring; inner ring; MS 17130 ; needle roller bearing; |
1.1 This specification covers inner rings for needle roller bearings with drawn outer rings.
1.2 The inner rings specified in this specification are intended for use on unhardened shafts in conjunction with open end needle roller bearings shown on Specification F2162 and MS52141.
1.3 The use of recycled materials that meet the requirements of the applicable material specification without jeopardizing the intended use of the item is encouraged.
1.4 The inner rings specified in this specification are not intended for use in flight-critical systems of aircraft.
1.5 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
Note 1: This specification contains many of the requirements of MS17130, which was originally developed by the Department of Defense and is currently maintained by the Defense Supply Center Richmond.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.