ASTM F2324-13R19 - Standard Test Method for Prerinse Spray Valves
Standard Test Method for Prerinse Spray Valves
| Standard number: | ASTM F2324-13R19 |
| Released: | 01.05.2019 |
| Status: | Active |
| Pages: | 11 |
| Section: | 15.12 |
| Keywords: | gallons per minute; force; force gauge; force test; prerinse spray valve; pre-rinse spray valve; prerinse; pre-rinse; spray force; spray valve; test method; |
1.1 This test method covers the water consumption flow rate and spray force of prerinse spray valves. The food service operator can use this evaluation to select a prerinse spray valve and understand its water consumption and spray force.
1.2 The following procedures are included in this test method:
1.2.1 Water consumption (see 10.2).
1.2.2 Spray force test (see 10.3).
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 This test method may involve hazardous materials, operations, and equipment. It does not address all of the potential safety problems associated with its use. It is the responsibility of the users of this test method to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to its use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.