ASTM F2793-24 - Standard Specification for Bicycle Grips
Standard Specification for Bicycle Grips
| Standard number: | ASTM F2793-24 |
| Released: | 01.06.2024 |
| Status: | Active |
| Pages: | 7 |
| Section: | 15.07 |
| Keywords: | bicycle; end closure; grip diameter; grip end diameter; grips; handlebar; |
1.1 This specification establishes a minimum outer diameter for the Bicycle Grip or End Closure, and the method for determining if the grip or End Closure meets the diameter.
1.2 This specification checks the following characteristics:
1.2.1 Bicycle Grip outer diameter,
1.2.2 Bicycle Grip or End Closure diameter or both, and
1.2.3 Bicycle Grip or End Closure retention or both.
1.3 This specification establishes testing requirements for the durability of Bicycle Grips and End Closures. It represents a performance standard and is not intended to dictate the design, materials, or construction of those closures.
1.4 Units—The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.