ASTM G0010-10R24 - Standard Test Method for Specific Bendability of Pipeline Coatings

1.1 This test method covers the specific determination of the effect of short-radius bends on coatings applied to 33.4 mm (1 in. nominal) diameter pipe.

1.2 The values stated in SI units to three significant decimals are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.