BS 5857-1.1:1980

This standard BS 5857-1.1:1980 Methods for measurement of fluid flow in closed conduits, using tracers. Measurement of water flow is classified in these ICS categories:

• 17.120.10 Flow in closed conduits

This International Standard deals with the measurement of water flow in closed conduits by using tracer methods; the flow of other liquids and of gases will be dealt with in subsequent International Standards

These methods apply to flow measurement in conduits into which a solution can be injected and those cases where effective mixing of this solution with the water flowing in the conduit can be achieved, this last condition being fundamental

Three fundamental procedures are used:

Two procedures, known as the constant rate injection method and the integration (sudden injection) method, are based on the dilution principle: a tracer solution is injected into the conduit and the dilution (ratio) of this tracer in the water flowing in the conduit is determined, this dilution being proportional to the rate of flow

The third is a method of measurement of the mean transit time (formerly called Allen velocity method): the tracer is injected into the conduit and the time taken by the tracer to travel a specified length between two cross-sections in each of which it is detected, is measured.

Compares dilution methods and methods based on transit time measurement. Also covers choice of tracers and measuring/mixing lengths.