PRICES include / exclude VAT
Homepage>BS Standards>33 TELECOMMUNICATIONS. AUDIO AND VIDEO ENGINEERING>33.060 Radiocommunications>33.060.99 Other equipment for radiocommunications>BS 6160-1:1989 Radio equipment used in mobile services General requirements and conditions of measurement
Sponsored link
immediate downloadReleased: 1989-09-29
BS 6160-1:1989 Radio equipment used in mobile services General requirements and conditions of measurement

BS 6160-1:1989

Radio equipment used in mobile services General requirements and conditions of measurement

Format
Availability
Price and currency
English Secure PDF
Immediate download
266.20 EUR
You can read the standard for 1 hour. More information in the category: E-reading
Reading the standard
for 1 hour
26.62 EUR
You can read the standard for 24 hours. More information in the category: E-reading
Reading the standard
for 24 hours
79.86 EUR
English Hardcopy
In stock
266.20 EUR
Standard number:BS 6160-1:1989
Pages:28
Released:1989-09-29
ISBN:0 580 17191 4
Status:Standard
DESCRIPTION

BS 6160-1:1989


This standard BS 6160-1:1989 Radio equipment used in mobile services is classified in these ICS categories:
  • 33.060.99 Other equipment for radiocommunications

This standard applies to radio transmitting and receiving equipment and systems used in the mobile services.

This standard is restricted to land and mobile stations in the mobile services and to portable and personal equipment which may operate in one or more radio-frequency channels in the frequency range below 1 000 MHz and is intended for the transmission and the reception, either in a simplex or a duplex mode, of emissions modulated by a single information channel.

In this standard, the equipment includes the aerial (antenna) change-over device or the duplexer, if used, but does not include:

  • the aerial (antenna) or aerial (antenna) system except in the case of equipment using integral aerials (antennas);
  • the input transducer of the transmitter;
  • the output transducer of the receiver except in the case of equipment using integral transducers (see note).

NOTE The performance of the equipment depends upon that of the input and the output transducers used. Assessing the performance of these transducers may be the subject of separate measurements which are outside the scope of this standard.

This standard also provides for testing certain special sub-systems (see Clause 10).