BS EN ISO 15156-3:2020
Petroleum and natural gas industries. Materials for use in H2S-containing environments in oil and gas production Cracking-resistant CRAs (corrosion-resistant alloys) and other alloys
| Standard number: | BS EN ISO 15156-3:2020 |
| Pages: | 80 |
| Released: | 2020-11-27 |
| ISBN: | 978 0 539 06871 9 |
| Status: | Standard |
BS EN ISO 15156-3:2020
This standard BS EN ISO 15156-3:2020 Petroleum and natural gas industries. Materials for use in H2S-containing environments in oil and gas production is classified in these ICS categories:
- 77.060 Corrosion of metals
- 75.180.10 Exploratory, drilling and extraction equipment
This document gives requirements and recommendations for the selection and qualification of CRAs (corrosion-resistant alloys) and other alloys for service in equipment used in oil and natural gas production and natural gas treatment plants in H2S-containing environments whose failure can pose a risk to the health and safety of the public and personnel or to the environment. It can be applied to help avoid costly corrosion damage to the equipment itself. It supplements, but does not replace, the materials requirements of the appropriate design codes, standards, or regulations.
This document addresses the resistance of these materials to damage that can be caused by sulfide stress cracking (SSC), stress corrosion cracking (SCC), and galvanically induced hydrogen stress cracking (GHSC).
This document is concerned only with cracking. Loss of material by general (mass loss) or localized corrosion is not addressed.
Table 1 provides a non-exhaustive list of equipment to which this document is applicable, including exclusions.
This document applies to the qualification and selection of materials for equipment designed and constructed using load controlled design methods. For design utilizing strain-based design methods, see ISO 15156-1:2020, Clause 5.
This document is not necessarily suitable for application to equipment used in refining or downstream processes and equipment.
| This document is applicable to materials used for thefollowing equipment | Exclusions |
|---|---|
| Drilling, well construction, and well-servicingequipment | Equipment exposed only to drilling fluids of controlledcomposition a Drill bits Blowout-preventer (BOP) shear blades b Drilling riser systems Work strings Wireline and wireline equipment c Surface and intermediate casing |
| Wells including subsurface equipment, gas liftequipment, wellheads, and christmas trees | Sucker rod pumps and sucker rods d Electric submersible pumps Other artificial lift equipment Slips |
| Flow-lines, gathering lines, field facilities, and fieldprocessing plants | Crude oil storage and handling facilities operating ata total absolute pressure below 0,45 MPa (65 psi) |
| Water-handling equipment | Water-handling facilities operating at a total absolutepressure below 0,45 MPa (65 psi) Water injection and water disposal equipment |
| Natural gas treatment plants | — |
| Transportation pipelines for liquids, gases, andmulti-phase fluids | Lines handling gas prepared for general commercialand domestic use |
| For all equipment above | Components loaded only in compression |
See ISO 15156-2:2020, A.2.3.2.3 for more information.
See ISO 15156-2:2020, A.2.3.2.1 for more information.
Wireline lubricators and lubricator connecting devices are not excluded.
For sucker rod pumps and sucker rods, reference can be made to NACE MR0176 .