PRICES include / exclude VAT
Homepage>BS Standards>17 METROLOGY AND MEASUREMENT. PHYSICAL PHENOMENA>17.120 Measurement of fluid flow>17.120.10 Flow in closed conduits>BS EN ISO 5167-5:2022 - TC Tracked Changes. Measurement of fluid flow by means of pressure differential devices inserted in circular cross-section conduits running full Cone meters
Sponsored link
immediate downloadReleased: 2022-11-10
BS EN ISO 5167-5:2022 - TC Tracked Changes. Measurement of fluid flow by means of pressure differential devices inserted in circular cross-section conduits running full Cone meters

BS EN ISO 5167-5:2022 - TC

Tracked Changes. Measurement of fluid flow by means of pressure differential devices inserted in circular cross-section conduits running full Cone meters

Format
Availability
Price and currency
English Secure PDF
Immediate download
372.68 EUR
English Hardcopy
In stock
372.68 EUR
Standard number:BS EN ISO 5167-5:2022 - TC
Pages:54
Released:2022-11-10
ISBN:978 0 539 24845 6
Status:Tracked Changes
DESCRIPTION

BS EN ISO 5167-5:2022 - TC


This standard BS EN ISO 5167-5:2022 - TC Tracked Changes. Measurement of fluid flow by means of pressure differential devices inserted in circular cross-section conduits running full is classified in these ICS categories:
  • 17.120.10 Flow in closed conduits
This document specifies the geometry and method of use (installation and operating conditions) of cone meters when they are inserted in a conduit running full to determine the flow rate of the fluid flowing in the conduit. As the uncertainty of an uncalibrated cone meter might be too high for a particular application, it might be deemed essential to calibrate the flow meter in accordance with Clause 7. This document also provides background information for calculating the flow rate and is applicable in conjunction with the requirements given in ISO 5167?1 . This document is applicable only to cone meters in which the flow remains subsonic throughout the measuring section and where the fluid can be considered as single-phase. Uncalibrated cone meters can only be used within specified limits of pipe size, roughness, ?, and Reynolds number, Re. This document is not applicable to the measurement of pulsating flow. It does not cover the use of uncalibrated cone meters in pipes sized less than 50 mm or more than 500 mm, or where the pipe Reynolds numbers are below 8 × 104 or greater than 1,2 × 107. A cone meter is a primary device which consists of a cone-shaped restriction held concentrically in the centre of the pipe with the nose of the cone upstream. The design of cone meter defined in this document has one or more upstream pressure tappings in the wall, and a downstream pressure tapping positioned in the back face of the cone with the connection to a differential pressure transmitter being a hole through the cone to the support bar, and then up through the support bar. Alternative designs of cone meters are available; however, at the time of writing, there is insufficient data to fully characterize these devices, and therefore, these meters shall be calibrated in accordance with Clause 7.
Email address into which you will receive a response
Your name