BS ISO 16365-2:2014
Plastics. Thermoplastic polyurethanes for moulding and extrusion Preparation of test specimens and determination of properties
| Standard number: | BS ISO 16365-2:2014 |
| Pages: | 22 |
| Released: | 2014-05-31 |
| ISBN: | 978 0 580 74124 1 |
| Status: | Standard |
BS ISO 16365-2:2014
This standard BS ISO 16365-2:2014 Plastics. Thermoplastic polyurethanes for moulding and extrusion is classified in these ICS categories:
- 83.080.20 Thermoplastic materials
This part of ISO 16365 specifies the methods of preparation of test specimens and the standard test methods to be used in determining the properties of thermoplastic polyurethane moulding and extrusion materials. Requirements for handling test material and for conditioning both the test material before moulding and the specimens before testing are also given.
Procedures and conditions for the preparation of test specimens in a specified state and procedures for measuring properties of the materials from which these specimens are given. Properties and test methods which are suitable and necessary to characterize thermoplastic polyester/polyurethane and polyether/polyurethane (TPU) moulding and extrusion materials, are listed.
The properties have been selected from the general test methods in ISO 10350. Other test methods in wide use or of particular significance to these moulding and extrusion materials are also included in this part of ISO 16365, as are the designatory properties specified in ISO 16365-1.
In order to obtain reproducible and comparable test results, it is necessary to use the methods of preparation and conditioning, the specimen dimensions, and the test procedures specified in this part of ISO 16365. Values determined are not necessarily identical to those obtained using specimens of different dimensions or prepared using different procedures.
NOTE This part of ISO 16365 has been developed on the basis of ISO 10350-1 as at the time of publication a standard on 'acquisition and presentation of comparable single point data' for thermoplastic elastomers' does not exist yet. After acceptance and publication of this part of ISO 16365, it is the intension to develop ISO 10350-3, based on the two International Standards mentioned before, as starting point for the development of thermoplastic elastomer material standards.