PRICES include / exclude VAT
Homepage>BS Standards>83 RUBBER AND PLASTICS INDUSTRIES>83.080 Plastics>83.080.01 Plastics in general>BS ISO 6721-7:2019 Plastics. Determination of dynamic mechanical properties Torsional vibration. Non-resonance method
Sponsored link
immediate downloadReleased: 2019-04-18
BS ISO 6721-7:2019 Plastics. Determination of dynamic mechanical properties Torsional vibration. Non-resonance method

BS ISO 6721-7:2019

Plastics. Determination of dynamic mechanical properties Torsional vibration. Non-resonance method

Format
Availability
Price and currency
English Secure PDF
Immediate download
191.18 EUR
You can read the standard for 1 hour. More information in the category: E-reading
Reading the standard
for 1 hour
19.12 EUR
You can read the standard for 24 hours. More information in the category: E-reading
Reading the standard
for 24 hours
57.35 EUR
English Hardcopy
In stock
191.18 EUR
Standard number:BS ISO 6721-7:2019
Pages:18
Released:2019-04-18
ISBN:978 0 580 97461 8
Status:Standard
DESCRIPTION

BS ISO 6721-7:2019


This standard BS ISO 6721-7:2019 Plastics. Determination of dynamic mechanical properties is classified in these ICS categories:
  • 83.080.01 Plastics in general

This document describes a torsional, non-resonance method for determining the components of the shear complex modulus G* of solid polymers in the form of bars or rods at frequencies typically in the range 0,001 Hz to 100 Hz. Higher-frequency measurements can be made, but significant errors in the dynamic properties measured are likely to result (see 10.2.1 and 10.2.2). The method is suitable for measuring dynamic storage moduli ranging from about 10 MPa, which is typical of values obtained for stiff rubbers, to values of about 10 GPa which are representative of fibre-reinforced plastics. Although materials with moduli less than 10 MPa can be studied, more accurate measurements of their dynamic properties can be made using simple shear (see ISO 6721-6) or torsional deformations of thin layers between parallel plates.

This method is particularly suited to the measurement of loss factors greater than 0,02 and may therefore be conveniently used to study the variation of dynamic properties with temperature and frequency through most of the glass-rubber relaxation region (see ISO 6721-1). The availability of data determined over wide ranges of both frequency and temperature enable master plots to be derived, using frequency-temperature shift procedures, which display dynamic properties over an extended frequency range at different temperatures.

NOTE

Although loss factors below 0,1 can be more accurately determined using the torsion pendulum (see ISO 6721-2), the method described in this document enables a much wider and continuous frequency range to be covered.


Email address into which you will receive a response
Your name